marrig – Plasticandplasters.com

1/8 Scale ’32 Ford “Big Deuce” – 03

Back to the red primer again for the dashboard & with just a light scraping of the edges & the

When I painted this MG MS-14A Gelgoog from Bandai way back in 2016 I wanted to paint most of the

While the wings are drying, I moved onto assembling the rear exhausts. Each exhaust unit consists of three parts: the

Ignition wiring is one of those details that separates a good engine bay from a great one. I wanted mine

Back to the chassis of the Peterbilt 395 with me fitting the front leaf springs & power steering box then

The front axle comes in 2 parts & the wheel hubs come in a upper and lower piece of plastic

Module 4: Well Heads and Drilling Platform Module 4 is where the well heads are located, and it’s also the

This is the page and post for the finished 1/24 GAT-X105 Ali Strike cockpit from BTF that I did back

After washing the frame to remove oils and dirt, I applied two fine coats of Halfords matte red base, sanding

Starting the Pretty Armor V3 Viper bike was exciting, especially with plans for a striking purple colour scheme to match